VERY USEFULL MCQ FOR ITI, RRB, BHEL, OFT, HAPP, APPRENTICE EXAMS, VOCATIONAL TRADE TRAINING, VOCATIONAL EDUCATION TRAINEE,ITI PREVIOUS YEAR QUESTION PAPERS 10 THOUSAND TECHNICAL MCQ AND ANSWERS
FITTER THEORY MCQ
An accident is ..............
a. Unplanned event
b.Undesirable event
c. Non-controlled event
d.All of these
Answer:d.All of these
An oily floor should be cleaned by
a. Cotton waste
b. Putting water
c. Putting saw dust
d. Spraying carbon dioxide
Answer:d. Spraying carbon dioxide
FITTER THEORY MCQ
Cyaniding and Nitricling are the two methods of which of the following process?
a; Hardening b) case Hardening c) Tempering d) Normalizing
Answer:b) case Hardening
Which tool is used to cut excessive thick sheet?
a) Snip b) Shear c) Hem d) None of these
Answer:b) Shear
Zinc coated sheet is krrown as
a) Tin coated sheet b) Galvanized iron sheet c) Stainless steel d) Lead sheet
Answer:b) Galvanized iron sheet
What is the full form of C'fC?
a) Carbon Tetra Chloride b) Carbon Tin Chloride c) Calcium Tetra Chloride
d) None of these
Answer:a) Carbon Tetra Chloride
FITTER THEORY
Which of the following is not related to marking media?
a) Layout Die b) Prussian Blue c) Surface plate d) None of these
Answer:c) Surface plate
There is negative error 0.03 mm in any micrometer. If the micrometer gives the reading
of 40.53 mm, then what will be the accurate readings?
a) 40.50 Millimeter b) -10.56 Millimeter c.140.83 Millimeter d) 40.23Millimeter
While marking from Vernier height gauge, it should be moved by holding its base in such
a way that: -
a) Main scale should bend
b) Zero error or main scale should check
c) Main scale should not bend
d) Base of the offset scriber should be parallel to the surface prate
Answer:c) Main scale should not bend
Maximum keys are rnade up of: -
a) High speed steel
b) Mild steel
c) Cast iron
d) Pig iron
Answer:b) Mild steel